To save the new setpoint value and exit, press setpoint again.

若要保存新的设定值并退出，请再次按设定值。

The flow rate is set and controlled by a user determined setpoint.

流速由用户确定的设定点设定并控制。

The change of the value for "machine output setpoint" is not accepted.

不接受“ 压片机输出设定值”的改变。

The setpoint setting range can be limited to a minimum (P05) and maximum (P06).

设定点设定范围可以限制在最低限度(P 05产)和最高(P 06)。

When altitude limitation is on the gas stick is now used to change the setpoint.

当高度限制是对气体棒现在用来改变设定值。

These alarms feature digital setpoint controls, delay timers, and universal inputs.

这些报警功能的数字设定点控制，延时定时器，和普遍的投入。

Large correcting effect maintains constant setpoint immune to supply pressure variations.

大型纠正效果设定值保持不变免疫供应压力变化。

The setpoint control of the Ievel is one of the principal factors that cause the flow oscillation.

液位的定值控制是造成物流频繁变化的主要因素之一。

It delivers accuracy with 0.025 psi Max supply pressure effect to hold setpoint regardless of fluctuating supply.

它提供0.025防扩散精度最高的供应压力的影响，不论持有设定点供应的波动。

Leads of single double contacts: lower limits is contact 2, upper limits setpoint is contact 1, contact 3 is public port.

表中双接点连接导线为：接点2为下限设定点，接点1为上限；设定点，接点3为公共端。

With its triple balanced range spring construction it holds a vacuum setpoint with the precision you need for tough applications.

其三平衡的范围春天它持有的建设与精确你很难申请的需要真空设定值。

When the setpoint of controlled variable varies, the controlling variable can be adjusted rapidly to maintain the dynamic stability of the welding process.

被控制量目标值变化时，控制量迅速随之调整，以保证焊接过程动态稳定。

Engineers and scientists can use the MPC feature to construct controllers that adjust the control action before a change in the output setpoint actually occurs.

工程师和科学家们可利用MPC的特征构建控制器，在设置点确实发生前调整控制行动。

While different coil strip enters a device, the data needs changing correspondingly. Whether control setpoint could be switched at correct time depends on correct material tracking.

当新的带钢进入某工艺设备时，控制设定值需要作相应变动，为了能使工艺设备在正确时刻切换控制设定值，就必须依靠正确的材料跟踪。

Its simple yet effective voice coil actuation now Locks in "Last Position" to accurately capture the setpoint with extremely low drift after a power loss permits the T6100 to maintain set point.

它的简单而有效的音圈驱动现在锁了“最后的位置”，以准确捕捉断电后，用非常低漂移设定值允许T6100，以维持设定点。

The principle of reactor trip protection system design and setpoint determination is that power plant operation range should be extended as large as possible on the basis of plant safety guaranteed.

在确保反应堆安全的基础上，尽量扩大电厂的运行区域是反应堆停堆保护系统设计以及整定值确定的原则。