This universal joint mounts to the bell crank and OSS Mount collet.

万向节安装到这个钟曲柄和OSS芒筒夹的应用。

The bell crank connects to a Tiller handle using a universal joint.

钟曲柄连接到一个使用通用蘖处理联合。

This shortened distance allows the installation of the Bell Crank mount.

缩短距离，这使曲轴安装贝尔芒。

Instruction for OSS configuration require the addition of a bell crank mount.

用于OSS的配置指令要求钟除了在曲柄安装。

If the OSS configuration is required, the Bell Crank Mount must be installed first.

如果开放源码软件的配置要求，贝尔曲柄芒必须先安装。

On the opposite end of the bell crank lever, both the steering tie rods are mounted.

论曲柄杠杆的另一端，无论是转向拉杆的安装。

If an OSS configuration is desired, the bell crank mount must be installed before any of the gussets are fastened in place.

如果一个开放源码软件配置不完善的地方，钟曲柄安装必须gussets安装前的任何固定的地方。

If the OSS configuration is required, the Bell Crank Mount must be installed first. Refer to the applicable section for details.

如果开放源码软件的配置要求，贝尔曲柄芒必须先安装。参照适用的细节部分。

A knuckle-to-knuckle Drag link provides continuity between the wheels, while the Tie Rod provides linkage to a Bell Crank (Pitman Arm).

一个指节到指节拉杆之间的连续性提供了车轮，而拉杆提供给贝尔曲柄连杆(必文臂)。

Instead of using two long steering control rods, the system USES a dual draglink system (as shown below) mounted to a simple bell crank.

而是用两个长转向控制，该系统采用双draglink系统(如下所示)安装在一个简单的钟曲柄。

The bell crank is attached to the universal joint, left and right tie rods, and to the trike frame. The bell crank assembly is shown below.

贝尔曲柄相连的万向节，左，右拉杆，并能三轮车框架。钟曲轴装配如下。

An adjustable position steering bell-crank is used to change steering Ackermann Settings.

一个可调的立场，督导钟曲柄是用来改变督导阿克曼设置。